Technical Parameter

•Set Pressure(Psi): 75,87,100,125,150psi  (0.5、0.6、0.7、0.8、1.0MPa)

•Set Pressure Tolerance: +5%,-10% of the set pressure.

•Set Temperature: From 65℃ to 99℃. (As you’re required)

•Set Temperature Tolerance: 99℃-5℃; other set Temperature is ±5℃

Installation

•Temperature and Pressure Relief Valves should be installed on the top of the water heater top or side. The  Temperature sensing element must be immersed in the water within the top 6″of the tank.

•The eliminating pipeline should be installed under the relief valve. Its terminal station distance in floor drain should  be  greater than 6″ to make it easily remove and observe water

Maintenance 

•After installing water heater the users must lift the relief valve handle once at least every year, so as to ensure  that unblocked things in the waterway of the relief valve.

•Before operating handles, please check the elimination pipeline which joining the relief valve, guaranteed that the hot  water from the relief valve discharge the proper place, otherwise it may cause the bodily injury.

•If the handle is lifted, without water flowing out, it proves that the relief valve is invalid. Then it should turn off the water  heater immediately and check the valve